Latest CNC Shield Version 3.0 for Arduino
GRBL 0.9 compatible (Open source firmware that runs on an UNO for Arduino that turns G-code commands into stepper signals)
4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using pins D12 and D13)
Jumpers to set the Micro-Stepping for the stepper drivers.
1. : |
- PWM Spindle and direction pins
|
2. : |
- 2 x End stops for each axis (6 in total)
|
3. : |
|
4. : |
- Uses removable A4988 or DRV8825 compatible stepper drivers
|
5. : |
|
6. : |
- Stepper Motors can be connected with 4 pin molex connectors or soldered in place
|
7. : |
- Runs on 12-36V DC. (At the moment only the DRV8825 drivers can handle up to 36V so please consider the operation voltage when powering the board.)
|
8. : |
- Please note that this is an unassembled kit and Basic soldering skills are needed
|
9. : |
|